Golden Rule Fasteners - RESIDENTIAL ZIPSEAL

Residential Zip-Seal ^TM
Also called Electrical Mast Flashing, Split Boot, Zipper Boot, Retrofit Flashing or Wrap Around Boot

THIS IS A ONE PIECE ELECTRICAL MAST FLASHING CLOSED WITH STAINLESS STEEL CLIPS.

YOU DON’T HAVE TO “SPIN” ANYTHING AND THERE ARE NO PLATES TO SCREW ON OR PIPE CLAMPS TO TIGHTEN

1) APPLY SHINGLES UP TO LOWER EDGE OF ELECTRICAL MAST
2) CUT FLASHING OPENING TO APPROPRIATE SIZE FOR YOUR PIPE

3) WRAP FLASHING AROUND ELECTRICAL MAST AND CLOSE BY CRIMPING ON STAINLESS CLIPS

4) APPLY SEALANT TO UNDERSIDE OF BASE AND SECURE BASE WITH ROOFING NAILS

5) APPLY SEALANT AROUND THE TOP OF THE ELECTRICAL MAST FLASHING WHERE IT MEETS THE PIPE, AND ALONG THE JOINER SEAM

6) FINISH APPLYING SHINGLES OVER SIDES AND UPPER PORTION OF ELECTRICAL MAST FLASHING BASE

NOTE: PROPERLY INSTALLED THE LOWER APPROXIMATELY 1/3 OF BASE WILL BE ON TOP OF SHINGLES AND THE UPPER APPROXIMATELY 2/3 OF BASE WILL BE COVERED BY SHINGLES AS SHOWN BELOW.

QUALITY MATERIAL AND DESIGN

MADE OF DURABLE EPDM RUBBER THIS NEW ELECTRICAL MAST FLASHING HAS A LIFE EXPECTANCY OF 20 YEARS IF USED WITHIN TEMPERATURE RANGE OF -58 DEG F TO 239 DEG F

GALVANIZED MESH REINFORCED BASE IS STRONG AND RIGID

PATTERNED AFTER THE METAL ROOF VERSION ALREADY TRIED AND PROVEN FOR YEARS

EXCEEDS DADE COUNTY CHAPTER 15 FLASHING REQUIREMENTS